CSR-12T-1B Control Module — 12V Replacement Receiver for Kids Ride On Cars

CSR-12T-1B Control Module

Restore full function to your child's ride-on car with the CSR-12T-1B Control Module, a genuine replacement 12V control box and remote receiver. This module is the core electronics unit that manages drive motors, steering, and communication with the parental remote control — if your child's car has stopped responding to the remote or lost drive power, a faulty control box is often the culprit.

Fitted with a 7-pin connector, the CSR-12T-1B is a plug-and-play replacement requiring no rewiring or soldering, and is confirmed compatible with several 12V models in our range.

Product Features

• 12V System — designed for 12-volt kids' electric ride-on vehicles
• 7-Pin Connector — matches the original wiring loom on compatible models, no rewiring needed
• Plug-and-Play Installation — swap out the old unit and reconnect in minutes
• Full Vehicle Control — governs drive motors, steering, and parental remote signal
• Genuine Replacement Part — built to the same specification as the original equipment

Product Specifications

Compatible Models

Confirmed compatible with:

• Lamborghini URUS Kids Ride On Car 12V With Parental Remote (BDM0923) — our licensed 12V Urus SUV with leather seats and EVA wheels
• CSR-12T-1B Remote Receiver for Range Rover Evoque Kids Car (DKRRE99) — see our dedicated Evoque receiver listing

This control box uses a widely-adopted 12V, 7-pin connector layout also found across a number of other 12V ride-on vehicles. If your car isn't listed above, open the control compartment and check the appearance, pin count, and part number against your existing unit before purchasing, or get in touch with our team for compatibility support.

How to Install

1. Switch off and disconnect the battery before starting.
2. Locate the existing control box in your child's ride-on car.
3. Note the position of the wiring connector before disconnecting.
4. Remove the old control box and connect the new CSR-12T-1B using the original 7-pin connector.
5. Reconnect the battery and re-pair your parental remote control following the instructions in your remote's manual.

FAQs

Is this the remote control itself?
No — this is the control receiver box that the remote pairs with, not the handheld remote unit.

Will my existing remote work with the new module?
In most cases yes, but the remote will need to be re-paired to the new receiver after installation.

How do I know if this is the right part for my car?
Open the control compartment and compare the appearance, connector pin count, and part number printed on your existing control box against the CSR-12T-1B before ordering.